Capacity:100L-5000LPrinciple：Confined to the surface of thermal-energy (such as hot water or low pressure steam the HTF), the heat was passed in the shell dry materials. In the drive, as slowly rotating the tank, the tank materials continuously mixed, so as to achieve the purpose of strengthening drying. Materials in a vacuum, steam decline in the material surface water (solvent) reached saturation point and evaporation, and the vacuum pump from the timely recovery. Materials internal water (solvent) continuously to the surface infiltration, evaporation from the three ongoing process, the material in a very short time to dry purpose. Application：Apply chemical, pharmaceutical, food and other industries powdery, granular and fiber concentration, mixing, drying and low-temperature drying of materials needed (such as biological and chemical products, etc.), applicable to more easily oxidized, volatile, thermosensitive strongly stimulate , toxic materials and not undermine crystal materials drying. Product Features：Heating oil, automatic temperature control, can be dry and biochemical products and mineral raw materials, the temperature can be 20 to 160 ℃. Thermal efficiency higher than the general oven raise more than two times. Indirect heating, the material will not be contaminated, with "GMP" requirement. Equipment maintenance is simple, easy to keep clean. Model recommended resettlement process: solvent recovery process resettlement.Note:Motor selection can be based on customer demands speed motor speed from 0 to 6 rpm; proportion of the above technical parameters of materials by 0.6 g/cm3, if exceeded, orders required by the users For Pressure Vessels certificates required by orders; flammable materials such as, when orders, whichever is the experimental data.
